dry magnetic separation machine parts maintenance and replacement instructions
Strong Bridge dry magnetic separator Network: dry magnetic separator maintenance and parts replacement instructions
Dry magnetic separator is an important MAG magnetitfilter mineral processing industry equipment , so dry magnetic separation machine repair and replacement parts that we need to master the basic repair skills , a strong bridge Heavy professional maintenance staff to introduce you to dry magnetic separator overhaul a few large parts of the repair skills !
1 , dry magnetic separation machine bearing lubrication and replacement.
Dry magnetic separator to work up to 300 hours, should be cleaned bearings. If the bearing is oil lubricated , add new oil bearing when the gap is filled 1/ 3 is appropriate , no more than 1/ 2 , before the job is often simply tighten the lid a little oil can lid . When dry magnetic separation machine bearings badly worn or damaged should be replaced , and pay attention to enhance the lubrication ; using tapered roller bearings , axial bearings should be careful to check the interval , 0.2-0.4 mm to keep it , if not , you can by increasing or decreasing at the pad of paper bearing cap to adjust .
2 , dry magnetic separator screen repair and replacement.
Mesh is made of steel sheet or a punched metal . When the screen appears worn or foreign material breakdown , if the damaged area is small , can make or soldering riveting repair method ; If extensive damage should be replaced with new sieve. When installing the screen , you should make the sieve with the burr side inward , outward smooth , sieve and sieve frame to fit tight. MAG ferrite magnet Ring sieve piece in the installation, which should overlap the inner layer of stubble along the direction of rotation to prevent the material stuck in the lap .
3 , the replacement of dry magnetic separator roller barrel .
Dry magnetic separator magnetic drum roll is dry magnetic separation machine wearing parts , but also affect the quality and productivity of the main components of magnetic separation , should be replaced after wear. Dry magnetic separator drum roll more time , you should use a circle hook spanner unscrew the nut , and then pull the child will roll special magnetic cylinder out. To ensure the operation of the rotor balancing , should pay attention to MAG hard ferrite magnets changing magnetic roller sets replace static balance test should be done after the change , so that the dry magnetic separator is stable . When assembling sure to tighten the nut and spring washer careful not to drain installation .
